Avoid making mistakes when identifying the 3 subparts of a lock : the barrel, the cylinder and the 3 sets of associated keys.

The data from a management system should be directly and indelibly marked on the subsets.

The Technifor solution consists of marking the 5 elements by micro-Percussion within the same marking cycle so as to avoid any possibility of separate a lock from its set of 3 keys.

Technifor has designed a set up to position the 5 elements in the same batch. The data to be marked will be entered by a bar code reading that will automatically inform the marking file's typing areas. The operator would only have to position the elements on the table, and then enter the number of batches to be marked. The PC will handle batch incrementation.

The composition of the marking files will have been pre-registered in a menu protected by a password known only to the supervisor, the only person authorized to modify the parameters of the file. When this is the case, a graphic preview of the file allows the position of the variable typing areas to be graphically modified. In the operator mode, a control mask allows you to preview the data before marking.

• CN210D Micro-Percussion marking head with a large marking area (200*100mm) assembled on a height-adjustable frame operated by a UC201 Central Control Unit.
• Setting-up for positioning and support of the 5 elements to be marked in the same marking cycle.
• Software for dynamic graphic preview under Windows NT
• Reading of data by a bar code reader on an RS232 cord connected to a PC serial port.